Outram Research Ltd
For cutting-edge power quality analysers and power quality monitoring equipment available to customers across the UK and internationally, look no further. Outram Research is an electronic design house specialising in the provision of state of the art electronics systems at system and sub-system level.
Outram Research offers solutions such as digital and analogue signal processing, Programmable logic design (FPGA) (EPLD), harmonics, windows applications and much more. The experienced team specialises in supplying products to some of the world's leading specialist engineering companies.
All Outram Research products are also available to hire, with discounts available for long-term product hire. Clients looking into support for Outram products can also request, technical, general and over-the-phone support from their knowledgeable team of experts.
Whether you are looking for the Power Master Series or one of Outram's own fault level monitors, Outram Research provides everything clients need for first-class power analysers and other products. Get in touch today or visit their website for more information on the products for sale and for hire.
Have you given it long enough to charge up slightly so it can automatically start its recording?
if you have left the unit on a shelf for a long period of time without charging it, it might take a few minutes to come back to life again. once the unit is plugged in and the battery has reached a reasonable level of charge, the lights on the front of the unit will start flashing again.
you might have to wait a minute or two for this to happen. once they do, check the green lights are flashing appropriately as your recording should then start up automatically.
Can the pm3000 interface to my network?
Yes it can. we can provide an ethernet to serial converter to enable your pm3000 to connect to your network. we’ve had a lot of success with moxa de311, just ask us for one.
Is the frequency measurement in the pm7000 derived from the v or i signal?
The pm7000 can track using any of v1, v2 or v3. v4 or the current channels are never used. the analyser will use v1 unless v2 or v3 are more than twice as big. also if the selected channel has less than (about) 4 volts rms then no frequency tracking is done, the pm7000 will keep running at the last known frequency.
this answer applies only to the pm7000, there are minor differences for the other products.
How long does the pm7000 stay in ‘discovery mode’ for bluetooth operations?
The pm7000 stays in ‘discovery mode’ for bluetooth for 1hr. it is stimulated and woken up by lifting and closing the lid on the unit. the bluetooth led on the top panel will flash twice every 4 seconds to show that the bluetooth is awake, then once connected that light will remain on. if the logger is on mains power or charger power the bluetooth will stay on all the time.
My functions panel has disappeared in the new version of pronto. can i get it back?
Any version of pronto for windows starting with 6. will have a screen specific functions panel which appears on the right hand side of the screen. if for any reason this has disappeared you can switch it on again by clicking on ‘view’ in the tool bar at the top of the page and selecting ‘functions panel’. this will bring it back into view.
View Full FAQ >>